The MG10 is a high power (80GN, 165 w/s) advance strobe in the N.A.S., Nissin Air System. The flexible handgrip arrangement which can be used both left and right side with height level adjustment.
Every single MG10 included a quick release mounting magnesium “L” bracket, AA battery magazine, Li-Ion battery magazine, ball head, filter holder and wide-angle diffuser.
There is a shutter release button on top of the handle and standard adapter screw under the flash head for using in the studio shooting. It also fully supports Air 10s and Air 1 commander wirelessly.
Above information is a test result record, it may be affected by equipment and environmental factors.
(*) Those functions depend upon the camera model, available in compatible cameras only.
Design and Specifications are subject to change without prior notice.
MG10 Firmware update
Check the firmware version
Power off. Press and hold the "Pilot" and "Power" button for 5 seconds. The LED of "Pilot" button will blink. The version of firmware is equal to the number of the blink.
Preparation for update
A Micro SD/SDHC card and Card reader.
full charged batteries.
Firmware update steps
1 - Download the Firmware file to your computer.
2 - Format your MicroSD card under FAT32 format. Copy firmware file to the card.
3 - Insert the card and switch MG10 on.
4 - The LED light will blink in orange then change into red light. Wait until the green light blinks, the update process completed.
5 - Remove the card. Switch on MG10. Firmware update completed.
Nissin end-user license agreement
By downloading firmware software of Nissin Digital Ltd. ("Nissin" ) from this site, you agree to the following terms and conditions. If you do not agree with such terms and conditions do not download the software. The terms of an end-user license agreement accompanying a particular firmware file upon installation or download of the firmware shall supersede the terms presented below.
The firmware is designed for use on Nissin product. Except as set forth below, such firmware is licensed to you subject to the terms and conditions of the end-user license agreement from Nissin governing your use of the firmware on Nissin product.
Disclaimer of warranties: you agree that Nissin has made no express warranties to you regarding the firmware and that the firmware is being provided to you "as is" without warranty of any kind. Nissin disclaims all warranties with regard to the software, express or implied, including, without limitation, any implied warranties of fitness for a particular purpose, merchantability, merchantable quality, or noninfringement of third-party rights.
Limit of liability: In no event will Nissin be liable to you for any loss of use, interruption of business, or any direct, indirect, special, incidental, or consequential damages of any kind (including lost profits) regardless of the form of action whether in contract, tort (including negligence), strict product liability or otherwise, even if Nissin has been advised of the possibility of such damages.
You shall not, or shall not have any third party, reverse-engineer, decompile, or disassemble this firmware.
I have read and understood the disclaimer above and wish to download the designated software