top of page

MG80 Pro

Out of battery is a big problem when shooting. 
Photographers keen on using Li-ion battery because it provides a better battery life and stable fast recycling time. MG80 Pro equipped the patented design "Wide Variety Battery System" to overcome the battery replacement challenge, which not only supports NiMH battery but also Li-ion (14500). Also, it is an advanced NAS 2.4GHz*1 Wireless built-in commander strobe for both on-camera and studio shooting.



MG80 Pro Components_2x.png


Above information is a test result record, it may be affected by equipment and environmental factors. 

(*) Those functions depend upon the camera model, available in compatible cameras only.

(*) When setting MG80 Pro on commander mode, Canon camera does not support 2nd curtain sync.

Design and Specifications are subject to change without prior notice.

Firmware update

MG80 Pro Firmware update

Check the firmware version

Air10 power on_2x.png

Power on MG80 Pro and wait to get ready. 

Air10 power hold_2x.png

Press and hold the Power button for 7 seconds.


The LCD display will show the 2 numbers of firmware version.


Release the Power button about 2 seconds, firmware version page will disappear and returns to the front operation page.

Preparation for update




A Micro SD/SDHC card and Card reader.


MG80 Pro with
full charged batteries.

Firmware update steps


1 - Download the Firmware file to your computer.

Format microSD_2x.png

2 - Format your MicroSD card under FAT32 format. Copy firmware file to the card.


3 - Insert the card and switch MG80 Pro on.


4 - The LED light will blink in orange then change into red light. Wait until the green light blinks, the update process completed.

MG10-microSD remove_2x.png

5 - Remove the card. Switch on MG80 Pro. Firmware update completed.

License Agreement

Nissin end-user license agreement

By downloading firmware software of Nissin Digital Ltd. ("Nissin" ) from this site, you agree to the following terms and conditions. If you do not agree with such terms and conditions do not download the software. The terms of an end-user license agreement accompanying a particular firmware file upon installation or download of the firmware shall supersede the terms presented below.

The firmware is designed for use on Nissin product. Except as set forth below, such firmware is licensed to you subject to the terms and conditions of the end-user license agreement from Nissin governing your use of the firmware on Nissin product.

Disclaimer of warranties: you agree that Nissin has made no express warranties to you regarding the firmware and that the firmware is being provided to you "as is" without warranty of any kind. Nissin disclaims all warranties with regard to the software, express or implied, including, without limitation, any implied warranties of fitness for a particular purpose, merchantability, merchantable quality, or noninfringement of third-party rights.

Limit of liability: In no event will Nissin be liable to you for any loss of use, interruption of business, or any direct, indirect, special, incidental, or consequential damages of any kind (including lost profits) regardless of the form of action whether in contract, tort (including negligence), strict product liability or otherwise, even if Nissin has been advised of the possibility of such damages.

You shall not, or shall not have any third party, reverse-engineer, decompile, or disassemble this firmware.

I have read and understood the disclaimer above and wish to download the designated software

The latest version










bottom of page